Oce Arizona 550 GT User Manual page 124

How to Load Media
Once you have aligned the media edges to the supply roll, without moving the media
3.
any further, tape the media to the platen.
[85] Tape the media edges to the platen
Pull the hanging media edge taut and cut the media off from each edge at an angle to
4.
result in a point just below the take-up core as shown here.
[86] Cut the media at an angle
124 Chapter 7 - How to Operate the Roll Media Option
User Manual: Arizona 550 GT - Version 1.2, Revision B - 2012