Configure Your Machine For A Wireless Network; Using The Setup Wizard From The Control Panel - Oce VL3200x User Manual

Configure your machine for a wireless network

IMPORTANT
• If you are going to connect your machine to your network, we recommend that you contact your system
administrator prior to installation. You must know your wireless network settings before you proceed
with this installation.
• If you have previously configured the wireless settings of the machine, you must reset the network LAN
settings before you can configure the wireless settings again. Press Menu, 7, 0 for Network Reset,
press 1 for Reset and then choose 1 for Yes to accept the change. The machine will restart automatically.

Using the Setup Wizard from the control panel

You can configure your machine by using the Setup Wizard function. This is located in the Network menu
on the machine's control panel. See to the steps below for further information.
a
Write down the wireless network settings of your access point or wireless router. If you do not know them,
contact your network administrator or the manufacture of your access point/router.
Check and record the current wireless network settings.
Network name:(SSID, ESSID)
Communication Mode
Infrastructure
Ad-hoc
1
Pre-Shared Key (PSK) lets the Océ machine associate with access points using TKIP or AES encryption. Pre-Shared Key is 8 or more
characters in length, up to a maximum of 63 characters.
Authentication method
Open system
Shared key
1
Pre-Shared Key
(WPA/WPA2-PSK)
LEAP
EAP-FAST/NONE
EAP-FAST/MS-CHAPv2
EAP-FAST/GTC
Open system
Configuring your machine for a wireless network
Encryption mode
Network key
2
WEP
NONE —
2
WEP
AES
TKIP
CKIP
AES
TKIP
2
WEP
NONE —
3
3
3
3
28