Oce VL3200x User Manual page 44

f
If the LCD shows Connected, the machine has successfully connected to your access point/router. You
can now use your machine in a wireless network.
If the LCD shows Connection Error, a session overlap has been detected. The machine has
detected more than one access point/router on your network with the automatic wireless setup mode
enabled. Make sure that only one access point/router has the automatic wireless setup
(SecureEasySetup™, AOSS™, etc.) mode enabled and try starting from step c again.
If the LCD shows No Access Point, the machine has not detected your access point/router on your
network with the automatic wireless setup (SecureEasySetup™, AOSS™, etc.) mode enabled. Move the
machine closer to your access point/router and try starting from step c again.
If the LCD shows Connection Fail, the machine has not successfully connected to your access
point/router. Try starting from step c again. If the same message is indicated again, reset the machine
back to the default factory settings and try again. (For resetting, see Restoring the network settings to
factory default on page 119.)
Configuring your machine for a wireless network
3
34