Control Panel Setup; Network Menu; Tcp/Ip - Oce VL3200x User Manual

6

Control panel setup

Network menu

Before using your machine in a network environment, you need to configure the correct TCP/IP settings.
In this chapter, you will learn how to configure the network settings using the control panel, located on the
front of the machine.
The Network menu selections of the control panel allow you to set up the machine for your network
configuration. Press Menu, then press a or b to choose Network. Proceed to the menu selection you wish
to configure. For additional information on the menu, see Function table and default factory settings
on page 209.
Please note that the machine is supplied with the BRAdmin Light utility and Remote Setup applications, which
also can be used to configure many aspects of the network. (See Changing the print server settings
on page 17.)

TCP/IP

If you connect the machine with an Ethernet cable to your network, use the Wired LAN menu selections. If
you connect the machine to a wireless Ethernet network, use the WLAN menu selections.
This menu has ten sections: Boot Method, IP Address, Subnet Mask, Gateway, Node Name,
WINS Config, WINS Server, DNS Server, APIPA and IPv6.
Boot Method
This selection controls how the machine obtains an IP address. The default setting is Auto.
Note
If you do not want your print server configured via DHCP, BOOTP or RARP, you must set the
Boot Method to Static so that the print server has a static IP address. This will prevent the print server
from trying to obtain an IP address from any of these systems. To change the Boot Method, use the
machine's control panel, BRAdmin Light utility, Remote Setup or Web Based Management (web browser).
a
Press Menu.
b
Press a or b to choose Network.
Press OK.
c
(For Wired) Press a or b to choose Wired LAN.
(For Wireless) Press a or b to choose WLAN.
Press OK.
d
Press a or b to choose TCP/IP.
Press OK.
e
Press a or b to choose Boot Method.
Press OK.
6
6
6
6
6
88