Table of Contents
Advertisement
The Rear Ports
Port
1
Power Switch
2
Power
3
Giga Ethernet
4
RESET
WPS
5
(BiPAC 9800N
only)
6
WAN
Antenna
7
(BiPAC 9800N
only)
Power ON/OFF switch.
Connect it with the supplied power adapter.
Connect to a PC or an office/home network of 10Mbps, 100Mbps or
1000Mbps using the provided RJ-45 Ethernet cables.
Press this button for more than 1 second to restore the device to its
default mode.
Push this button to trigger Wi-Fi Protected Setup function.
There are several options for fiber WAN interface and they do not coexist.
Note: Please refer to the instructions on the label of the outer box to
get the specification of your device.
Single SC Port:
• 100BASE-BX: A single strand of optical fiber. Single-mode fiber
is used (Tx1310nm/Rx1550nm). It supports SC connector.
• 1000BASE-BX: A single strand of optical fiber. Single-mode
fiber is used (Tx1310nm/Rx1490nm). It supports SC connector.
Dual SC Ports: According to transmission method, the dual fiber WAN
interface is separated into single mode and multi mode.
•
100BASE-LX/SMF
of optical fiber, one for receive(RX) and the other for
transmit(TX). Single-mode fiber is used (Tx/Rx1310nm). It
supports SC connector.
• 100BASE-FX/MMF: Two strands of optical fiber, one for
receive(RX) and the other for transmit(TX). Multimode fiber is
used (Tx/Rx1310nm). It supports SC connector.
SFP Port:
SFP: A cage for SFP (Small Form-Factor Pluggable) transceiver-
100BASE or 1000BASE optical convector.
Connect the detachable antenna to this port.
Meaning
& 1000BASE-LX/SMF: Two strands
9
Advertisement
Table of Contents
