Table of Contents
Advertisement
Quick Start Guide
Hardware Overview
The Front LEDs
When the power is on it will be
lit green. When the system is
booting it will blink orange.
When the system is ready it
will be lit green. When system
boot fails or if in emergency
mode, it will be lit orange.
Lit orange when one of LAN
ports is connected to an
Ethernet device. Lit green when
the speed of transmission hits
1000Mbps; Lit orange when the
speed of transmission hits
10/100Mbps. Blinking when data
is transmitted/ received.
The Rear Ports
Single SC Port
(BiPAC 9800N only)
Connect the
detachable antenna
Connect the fiber cable to the WAN port. There
are 2 options for single SC interface:
100Base-BX and 1000Base-BX, and they do not
coexist. Please refer to the figures shown
below. *2
(BiPAC 9800N only)
Lit green when a wireless
connection is established.
Flash green when data is
transmitted/received.
(BiPAC 9800N only)
Flash green when WPS
configuration is in
progress. However, if WPS
fails, the LED will only lit for
1 min before goes off.
Press more than 1
second to restore
the device to its
default mode
(BiPAC 9800N only)
Push WPS button to
trigger Wi-Fi Protected
Setup function
-2-
Connect your computer
to a LAN port using the
included Ethernet cable
(with RJ-45 cable)
*
1
Lit green when the device is
connected to a broadband
connection device.
Blinking when data is
transmitted/received.
Lit orange when WAN port fails
to get IP address. Lit green
when WAN port gets IP address
successfully. Lit off when the
device is in bridge mode or
when WAN connection absent.
Connect the
supplied power
adapter to this jack
Power ON/OFF
switch
Advertisement
Table of Contents
