Table of Contents
Advertisement
Hardware Overview
BiPAC 5210S RC
The Front LEDs
Lit red when power is
ON. Lit green when
the system is ready.
Lit when connected to an
Ethernet device. Lit green
for 10M or 100M. Blinking
when data is Transmitted /
Received.
The Rear Ports
Connect a UTP Ethernet
cable (Cat-5 or Cat-5e)
to the Ethernet port
when connecting to a
PC or an office/home
network of 10Mbps or
100Mbps.
Connect the supplied RJ-11
("telephone") cable to this
port when connecting to the
ADSL / telephone network.
2
Lit when the device
is connected to the
PC and is working
properly.
Lit when successfully
connected to an ADSL
DSLAM ( "linesync" )
After the device is powered on, press it
to reset the device or restore to factory
default settings. 0-3 seconds: reset the
device; 6 seconds above: restore to
factory default settings (this is used
when you cannot login to the router, e.g.
forgot the password)
User can connect to PC
using an alternative USB
cable through this port.
Quick Start Guide
Lit red when WAN fails
to get IP address. Lit
green when WAN gets
the IP address.
Power
On/Off
switch.
Connect the
supplied power
adapter to this jack.
Advertisement
Table of Contents
