Hardware Overview; Quick Start Guide; The Front Leds; The Rear Ports - Billion BiPAC 7800(N) Quick Start Manual

Hardware Overview

The Front LEDs

When power on, it will lit green.
When the system is booting, it
will blink orange at the same
time. While the system is ready,
it will only lit green. When
system booting failed or in the
emergency mode, it will only lit
orange.
Lit when connected to an
Ethernet device.
Lit green for 1000Mbps;
Lit orange for 10/100Mbps.
Blinking when data is being
Transmitted / Received.

The Rear Ports

Connect the
detachable antenna
Connect the supplied
RJ-11 cable to this port
when connecting to the
ADSL/telephone
network
Lit when connected to a
broadband connection device.
Lit orange for 10/100Mbps.
Blinking when data is
transmitted / received.
Lit green when a wireless
connection is established. Lit
orange when WPS is enabled.
Flash green when data is sent /
received.
WAN 10/100M Ethernet port
(with auto crossover
support); connect Cable
Modem, VDSL, and Fiber
Modem or PON optic lines
with your RJ-45 cable
Connect your computer
to a LAN port, using the
included Ethernet cable
(with RJ-45 cable)
Press it to reset
the device or
restore to factory
default settings
2-
-

Quick Start Guide

Lit Green when
successfully connected
to an ADSL DSLAM,
("line sync").
Lit orange when WAN port
fails to get IP address. Flash
green when WAN port gets IP
ad dress successfully and
when data is transmitted.
Connect the
supplied power
adapter to this jack
Power
ON/OFF
switch
Push WPS button to
trigger Wi-Fi Protected
Setup