Advertisement
Quick Start Guide
Hardware Overview
The Front LEDs
Lit orange when
power is ON,
Lit green when the
system is ready.
Lit red means system
failure
The Rear Ports
Connect the
detachable antenna
Connect RJ-11 cable
to this port when
connecting to the
telephone wall jack
Lit when connected to an
Ethernet device.
Green for 100Mbps;
Orange for 10Mbps.
Blinking when data is
Transmitted / Received
Lit green when the
wireless connection is
established.
Flashes when sending /
receiving data.
Connect your
computer to a
LAN port, using
the included
Ethernet cable
Connect RJ-11 cable
to this port when
connecting to an
analog phone set
2-
-
Lit when the SIP
Registration is OK.
Lit green whenever
phone 1 is off hook
but will lit orange
for phone 2
Lit green
when the
phone is
off-hook
Lit green when the
inbound and
outbound calls are
transmitted through
PSTN.
Press it to reset
the device or
restore to factory
default settings
WAN 10/100M Ethernet
port (with auto
crossover support);
connect xDSL/ Cable
modem here.
Lit green or orange
when connected to a
modem or Cable
modem's Ethernet port
well.
Lit green when IP connected.
Flashes green when IP connected
and IP traffic is passing through
the device. Lit red when device
attempted to become IP
connected and failed. Lit off when
device in bridged mode or when
connection WAN is absent.
Connect the
supplied power
adapter to this jack
Power
ON/OFF
switch
Push WPS button to
trigger Wi-Fi Protected
Setup
Advertisement
