Hardware Overview; The Front Leds; The Rear Ports - Billion BiPAC 7404VNOX Quick Start Manual

Quick Start Guide

Hardware Overview

The Front LEDs

Lit orange red when
power is ON. Lit red
means system is fail.
Lit green when the
system is ready.
Lit when connected to an
Ethernet device.
Lit Green for 1000Mbps;
Orange for 100Mbps; but
no light for 10Mbps.
Blink when data is being
Transmitted / Received.

The Rear Ports

Connect with Connect to the
the detachable telephone jack on the
antenna.
wall with RJ-11 cable.
Connect to the ADSL /
telephone network with
RJ-11 cable (telephone).
Lit green when the
USB device is ready.
Flash when data is
being transmitted /
received.
Lit green when a
wireless connection is
established. Flash green
when the device is
sending/receiving data.
Connect to a PC or an
office/home network
of 10/100/1000Mbps
with UTP Ethernet
cable.
3G/ HSDPA USB
modem backup for
Internet access
Connect to an
analog phone set
with RJ-11 cable.
2-
-
Lit green when SIP
registration is ok for phone
1 or orange for phone 2.
When registration for both
phone 1 & 2 are ok, both
green and orange light will
lit together.
Lit green
when the
phone is
off hook
Lit green when the
inbound and outbound
calls are transmitted
through PSTN.
Press the RESET
button for 6
seconds and
above to restore
the factory
default settings.
Push to trigger Wi-Fi
Protected Setup
function.
Lit Green when
successfully
connected to an
ADSL DSLAM,
("line sync").
Lit red when WAN port fails to
get IP address. Lit green when
WAN port gets IP address
successfully. Lit off when device
in bridged mode or WAN
connection not present.
Connect it with the
supplied power
adapter.
Power
ON/OFF
switch