Advertisement
Hardware Overview
BiPAC 5200 RC
The Front LEDs
The Rear Ports
Power ON /
OFF switch.
Connect with
the supplied
power adapter.
2
Lit red when power is
ON. Lit green when
the system is ready.
Blink when data is being
Transmitted / Received. Lit
off when the connection
not present.
Connect to a home / office
network device (eg. PC) of
100Mbps or 10Mbps with
the supplied UTP Ethernet
cable (CAT-5).
When the device power is on, press to reset
or to restore its factory default setting.
Press 1-3 seconds to reset the device. Press
6 seconds and above to restore the device
factory default setting. Caution: After
pressing the RESET button for more than 6
seconds, to be sure you power cycle the
device again.
Lit Green when the
device is successfully
connected to an ADSL
DSLAM. ("Line sync").
Lit red when WAN port fails
to get IP address. Lit green
when WAN port gets IP
address successfully.
Connect to a
telephone network /
ADSL using the
provided RJ-11 cable.
Quick Start Guide
Advertisement
