Hardware Overview; The Front Leds; The Rear Ports - Billion BiPAC 7401V(G)PX Quick Start Manual

Hardware Overview

The Front LEDs

Lit when connected to an
Ethernet device.
Green for 100Mbps;
Orange for 10Mbps.
Blink when data is
Transmitted / Received.
Lit orange red when
power is ON. Lit red
means system is fail.
Lit green when the
system is ready.

The Rear Ports

Connect the
detachable
antennato this port.
Connect this port to the
ADSL/telephone network
with the RJ-11 cable
(telephone) provided.
Lit green when the
USB device is ready.
Flashes when
sending/ receiving
data.
Lit green when a
wireless connection is
established. Flash
when the device is
sending/receiving data.
Connect this port to
the telephone jack on
the wall with RJ-11
cable.
Connect this port to
an analog phone set
with RJ-11 cable.
Lit green when the
SIP Registration is
OK.
Lit green when the
phone is off hook.
Lit when the inbound
and outbound calls
are transmitted
through PSTN.
Press it to reset
the device or
restore to factory
default settings
3G/ HSDPA USB
modem backup for
Internet access
Connect a UTP Ethernet
cable (Cat-5 or Cat-5e) to
one ofthe LAN ports when
connecting to a PC or an
office/home network of
10Mbps or 100Mbps.
-2-
Quick Start Guide
Lit Green when the device is
successfully connected to an
ADSL DSLAM. ("line sync")
Lit red when WAN port fails
to get IP address. Lit green
when WAN port gets IP
address successfully. Lit off
when device in bridged
mode or WAN connection
not present.
Connect the
supplied power
adapter to this jack
Power
ON/OFF
switch
Push WPS button to
trigger Wi-Fi Protected
Setup function.