Table of Contents
Advertisement
Quick Start Guide
Hardware Overview
The Front LEDs
When the device is booting, the
green light will be lit and the red
light will flash. When the system
is ready, it will be lit green. Lit
red when the device fails to boot
or when the device is in
emergency mode.
Lit up steady when connected
to an Ethernet device. Lit
green when the speed of
transmission hits 100Mbps;
Lit orange when the speed of
transmission hits 10Mbps.
Blinking when data is
transmitted/received.
The Rear Ports
Connect the
Connect your computer
detachable
to a LAN port using the
antenna for
included Ethernet cable
wireless
(with RJ-45 cable)
connection
Connect the supplied
RJ-11 cable to this port
when connecting to the
ADSL/telephone
network
* Note: For WPS configuration, please refer to the WPS section of User Manual.
Lit green when 3G service is
ready. Blinking orange slowly
when 3G signal is weak;
blinking orange fast when 3G
signal is middle; lit up orange
steady when 3G signal is
strong. Lit off when there is
no 3G signal.
Lit green when a wireless
connection is established. Flash
orange when WPS configuration is
in progress. However, if WPS fails
the LED will only lit for 1 min
before goes off. Blinking when
data is transmitted/received.
Press for more than
1 second to restore
the device to its
default mode
Insert a SIM card
into this slot.
-2-
Lit green when the
device is successfully
connected to an ADSL
DSLAM. ("line sync")
Lit red when WAN port fails
to get IP address. Lit green
when WAN port gets IP
address successfully. Lit off
when the device is in bridge
mode or when ADSL
connection is absent.
Connect the detachable
antennas to these two
ports for 3G connection.
Power
ON/OFF
switch
3G Antenna
Connect it with
the supplied
power adapter.
Push WPS button to
trigger Wi-Fi Protected
*
Setup function
Advertisement
Table of Contents
