Gateway E-9232T User Manual page 42

To replace, add, or reseat a PCI expansion card:
1
2
3
4
Card retention bar
Captive thumbscrew
5
36
CHAPTER 4: Installing Components
Follow the instructions in
Follow the instructions in
If you are replacing a card, disconnect any cables that are attached to the old card.
Loosen the captive thumbscrew on the card retention bar and swing the bar out from the
back of the chassis.
If you are replacing a card, remove the old expansion card. To loosen the card you can
slightly rock the card end-to-end, but do not bend the card sideways.
Caution
Do not touch the contacts on the bottom part of the expansion card.
Touching the contacts can cause electrostatic damage to the card.
"Preventing static electricity discharge" on page
"Opening the server case" on page
PCI slot 1
PCI slot 2
PCI slot 3
PCI slot 4
PCI slot 5
18.
19.