Replacing The Cmos Battery - Gateway E-9232T User Manual

To replace a back fan:
1
2
3
4
5
6
7
8

Replacing the CMOS battery

the same or equivalent type of battery recommended by the manufacturer. Dispose of used
batteries following the manufacturer's instructions.
If the server clock does not keep time or the settings in the BIOS Setup utility are not saved when
you turn off the server, replace the CMOS battery with an equivalent battery.
To replace the battery:
1
2
www.gateway.com
Follow the instructions in
Follow the instructions in
Unplug the fan cable from the fan connector on the system board.
Unscrew the four fan retention screws holding the fan to the back of the chassis.
Pull the fan from the chassis, noting the orientation.
Important
Make sure that the new fan is oriented the same way (air flow) as the old fan.
Insert the new fan into the chassis, then replace the fan retention screws.
Plug the fan cable into the fan connector on the system board.
Follow the instructions in
Warning
There is a danger of explosion if battery is incorrectly replaced. Replace only with
Print the appendix for BIOS Settings
Follow the instructions in
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Closing the server case" on page
in this guide.
"Opening the BIOS Setup utility" on page
18.
19.
Fan cable
Fan retention screw
Fan retention screw
24.
48.
43