Lexmark 13P0150 - C 750dtn Color Laser Printer Service Manual page 33

Error code
172 Motor
173 Motor
174 Motor
175 Motor
176 Motor
180 PSD Error
181 PSD Error
182 PSD Error
183 PSD Error
5060-XXX
Action
Mirror motor lost lock - Cyan - Replace the Cyan Printhead
Assembly - Go to "Printheads" on page
Note: Whenever the printhead assembly is replaced it is necessary
to perform the "Printhead Adjustments" on page
Mirror Motor lock not achieved - Magenta - Replace the following
FRU:
"RIP Board" on page 4-11
If this does not fix the problem, replace:
Magenta Printhead Assembly - Go to
Note: Whenever the printhead assembly is replaced it is necessary
to perform the "Printhead Adjustments" on page
Mirror motor lost lock - Magenta - Replace the Magenta Printhead
Assembly - Go to "Printheads" on page
Note: Whenever the printhead assembly is replaced it is necessary
to perform the "Printhead Adjustments" on page
Mirror Motor lock not achieved - Yellow - Replace the following
FRU:
"RIP Board" on page 4-11
If this does not fix the problem, replace:
Yellow Printhead Assembly - Go to
Note: Whenever the printhead assembly is replaced it is necessary
to perform the "Printhead Adjustments" on page
Mirror motor lost lock - Yellow - Replace the Magenta Printhead
Assembly - Go to "Printheads" on page
Note: Whenever the printhead assembly is replaced it is necessary
to perform the "Printhead Adjustments" on page
PSD sensor error (Black) - Replace the Black
Assembly" on page 4-34.
Note: It is necessary to remove the Printhead Assembly to access
the PSD Sensor Assembly, therefore it is necessary to perform the
"Printhead Adjustments" on page
PSD sensor error (Cyan) - Replace the Cyan
Assembly" on page 4-34.
Note: It is necessary to remove the Printhead Assembly to access
the PSD Sensor Assembly, therefore it is necessary to perform the
"Printhead Adjustments" on page
PSD sensor error (Magenta) - Replace the Magenta
Assembly" on page 4-34.
Note: It is necessary to remove the Printhead Assembly to access
the PSD Sensor Assembly, therefore it is necessary to perform the
"Printhead Adjustments" on page
PSD sensor error (Yellow) - Replace the Yellow
Assembly" on page 4-34.
Note: It is necessary to remove the Printhead Assembly to access
the PSD Sensor Assembly, therefore it is necessary to perform the
"Printhead Adjustments" on page
4-33.
4-1.
"Printheads" on page
4-1.
4-33.
4-1.
"Printheads" on page
4-1.
4-33.
4-1.
"PSD Sensor
4-1.
"PSD Sensor
4-1.
"PSD Sensor
4-1.
"PSD Sensor
4-1.
Diagnostic Information
4-33.
4-33.
2-13