Lexmark 13P0150 - C 750dtn Color Laser Printer Service Manual page 57

User Primary
Message
52 Flash Full
53 Unformatted Flash
54 Std Par ENA
Connection Lost
54 Std Network
Software Error
54 Network x Software
Error
5060-XXX
User Secondary Message Explanation
This message will be displayed when there is not
enough free space in the flash memory to hold
the resources that have been requested to be
written to flash.
Note: The following action will delete all
downloaded Fonts and Macros written to disk:
*Press Go to clear the message and continue
processing the print job.
* Press >Menu or Menu< to access the Busy/
Waiting Menu group
The following functions may be available:
* Cancel Job
* Reset Printer
* Reset Active Bin
* Check Supply Levels
Note: Menu Lockout does NOT prevent access to
the Busy/Waiting Menu Group.
This message will be displayed when the printer
detects an unformatted flash at POST.
The following actions can be taken while this
message is displayed:
* Press Go to clear the message.
The flash will be marked bad and normal
operation will continue. Flash operations will not
be allowed until the flash is formatted.
This message will be displayed when the printer
detects during POST that the connection to an
ENA has been lost. Once a connection is initially
established, a printer setting is modified to 54 Par
x ENA to note a connection exists. Each time the
power is cycled on, the connection is lost.
This message will be displayed when the RIP
software has detected that a network port is
installed but cannot establish communications
with it.
The following actions can be taken while this
message is displayed:
* Press Go to clear this message.
The printer will disable all communications to the
associated network interface. No data may be
received or sent from or to the associated
interface. The user cannot program new firmware
in the network via the parallel port after this
message has been cleared.
Diagnostic Information
2-37