Lexmark 13P0150 - C 750dtn Color Laser Printer Service Manual page 46

User Primary
Message
280 Paper Jam Clear
Paper Path
282 Staple Jam Check
Stapler
283 Staple Jam Check
Stapler
Setup Required
A Alignment =X.X*
2-26
Service Manual
User Secondary Message
Leave Job in Finisher
5060-XXX
Explanation
Primary: Media has jammed in the Finisher
Option, open the Finisher Option Side door to top
cover to access the jammed pages.
Secondary: If sheets have been accumulated to
be stapled when the jam is detected, the printer
alternately flashes the primary and secondary
messages indicating the accumulated sheets
should not be removed during jam clearance.
Note: When the secondary message is displayed,
if the accumulated sheets are removed the printer
will not reprint these sheets. Also if the print job is
completed, the portion of the job printed after the
jam will not be stapled.
These messages will be displayed when the
stapler device detects a paper jam.
282 Staple Jam message indicates that a staple
jam has been detected during normal stapler
operation such as when printing and stapling
jobs.
283 Staple Jam message indicates that a staple
jam has been detected during a priming
operation. No secondary message will be
displayed.
Note: After the error has been cleared, the printer
does not reprint any pages which existed in the
accumulator for stapling.
The following actions can be taken while either
the primary or secondary messages are
displayed:
* Press Go to initiate priming and resume
printing.
Note: Use of the Sub Error Code Chart may help
in diagnosing 282 and 283 Errors.
This message will be displayed when the printer
has detected at POST, that packing material is
still installed and must be removed. The user
should verify that the machine is properly setup.
* Press Go and Reflash Code.
This message will be displayed when an ITU
Alignment Procedure is in process and the printer
is prompting the user for the X (X=A thru L)
alignment value. Alignment values for A thru L
(=X.X*) -7 to +7 in 0.5 increments.
* Enter the alignment value and press Select to
continue to the next alignment value.
* To abort the alignment operation press Go or
Return.