Lexmark 13P0150 - C 750dtn Color Laser Printer Service Manual page 40

2xx Primary
code Message
203 Paper Jam
Clear paper Path
230 Paper Jam
Clear Paper Path
24x Paper Jam
Clear Paper Path
2-20
Service Manual
5060-XXX
Secondary
Message
Leave Job in Finisher
Leave Job in Finisher
Leave Job in Finisher
Description
Primary: The media is jammed due to a
transparency sensor mismatch. Open the printer
left door to access the jammed media. If sheets
have been accumulated to be stapled or offset
when the jam is detected, the printer alternately
flashes the primary and secondary messages to
indicate that all accumulated sheets should not
be removed during the jam clearance procedure.
Secondary: When this message is displayed, do
not remove accumulated sheets during the jam
clearance procedure. The printer will not reprint
the removed sheets. Also, if the accumulated
sheets are removed, the portion of the job printed
after the jam will not be stapled.
Primary: The media is most likely jammed in the
duplex unit, remove the duplex tray to access the
jam area. If sheets have been accumulated to be
stapled or offset when the jam occurred, the
printer alternately flashes the primary and
secondary messages to indicate that all
accumulated sheets not be removed during the
jam clearing procedure.
Secondary: When this message is displayed, do
not remove accumulated sheets during the jam
clearance procedure as the printer will not reprint
the removed sheets. Also, if the accumulated
sheets are removed, the portion of the job printed
after the jam will not be stapled.
Primary: Media is jammed around Tray x (Tray
x=2 through 4) and applies to both a 500 Tray and
HCIT tray. Try opening Tray x. If the tray is difficult
to remove then you may need to remove the tray
above or below Tray x to remove the jam. If
sheets have been accumulated to be stapled or
offset when the jam occurred, the printer
alternately flashes the primary and secondary
messages to indicate that all accumulated sheets
not be removed during the jam clearing
procedure.
Secondary: When this message is displayed, do
not remove accumulated sheets during the jam
clearance procedure as the printer will not reprint
the removed sheets. Also, if the accumulated
sheets are removed, the portion of the job printed
after the jam will not be stapled.