Autocompensator Service Check - Lexmark 13P0150 - C 750dtn Color Laser Printer Service Manual

Step Action and Questions
2
Check to make sure the autocompensator has fully
retracted to its upper position.
Does the Autocompensator retract correctly?
3
Check for any signs of damage to the Paper Tray Guide.
Is the paper tray guide damaged, loose or missing?
4
Check the following parts for any signs of wear, damaged or
missing parts.
* Wear Strips
*Restraint Pads
* Wear Clip
* Side Restraint
* Back Restraint and Back Restraint Latch
Are any of the parts broken, worn or missing?

Autocompensator Service Check

If the paper fails to feed from Tray 1, go to
If the autcompensator fails to lower when Tray 1 is installed,
go to
If the autocompentator fails to retract when you attempt to remove Tray 1,
go to
If there is no indication that the media is out or low, go to
If the printer fails to detect transparencies and 203 Paper Jam displays,
go to
Note: When feeding paper through the printer to check for autocompensator problems
use the Tray 1 Feed test in the CE Diagnostics as a printed copy is not required.
5060-XXX
"Step B" on page 2-92.
"Step C" on page 2-92.
"Step E" on page 2-94.
Yes
Go to step 3
Replace the
Paper Tray
Guide.
Repair or
replace parts
as necessary
"Step A" on page 2-92.
"Step D" on page
Diagnostic Information
No
Go to the
"Autocompe
nsator
Service
Check" on
page 2-91
Go to the
"Autocompe
nsator
Service
Check" on
page 2-91
Go to the
"Autocompe
nsator
Service
Check" on
page 2-91
2-93.
2-91