Sub Error Code Table - Lexmark 13P0150 - C 750dtn Color Laser Printer Service Manual

Error code
193 PSD Error
194 PSD Error
195 PSD Error

Sub Error Code Table

The Sub-Error code table may be helpful troubleshooting the printer when 9xx and 1xx
Error Codes have been displayed.
When a 9xx or 1xx Error Code is displayed, press and hold Return and press Select to
view the Sub Error Code.
Sub Error Code Explanation
2D 00 No media available in Duplex unit.
2D 02 Paper jam detected. Sensor S2 was activated at an unexpected time.
2D 03 Paper jam detected. Sensor S2 was not activated within the time-out period.
2D 04 Paper jam detected. Sensor S2 did not deactivate during the time-out period.
2D 05 Paper jam detected. Sensor NM in the fuser was activated at an unexpected time.
2D 06 Paper jam detected. Sensor NM in the fuser did not deactivate during the time-out
period.
2D 07 Paper jam detected. The fuser exit sensor was activated at an unexpected time.
2D 08 Paper jam detected. The fuser exit sensor did not deactivate by the previous page or
the current page did not activate the fuser exit sensor within the time-out period.
2D 09 Paper jam detected. The fuser exit sensor did not deactivate during the time-out period.
2D 0A Paper jam detected. A paper jam detected in the Duplex unit.
2D 0B Paper jam detected. A paper jam detected in Tray 2.
2D 0C Paper jam detected. A paper jam detected in Tray 3.
2D 0D Paper jam detected. A paper jam detected in Tray 4.
5060-XXX
Action
No EOS reading (Cyan) - Go to
page 2-88.
Note: It is necessary to remove the Printhead Assembly to access
the PSD Sensor Assembly, therefore it is necessary to perform the
"Printhead Adjustments" on page
No EOS reading (Magenta) - Go to
page 2-88.
Note: It is necessary to remove the Printhead Assembly to access
the PSD Sensor Assembly, therefore it is necessary to perform the
"Printhead Adjustments" on page
No EOS reading (Yellow) - Replace the Yellow
Assembly" on page 4-34.
Note: It is necessary to remove the Printhead Assembly to access
the PSD Sensor Assembly, therefore it is necessary to perform the
"Printhead Adjustments" on page
"PSD Service Check" on
4-1.
"PSD Service Check" on
4-1.
"PSD Sensor
4-1.
Diagnostic Information
2-15