Table of Contents
Advertisement
Using balloon help
Balloon Help works on all versions of MacOS from 7.1
upwards. By displaying Balloon Help, you can get a
simple explanation of each function. Follow the steps
below to use Balloon Help.
1.
Select
Show Balloons
(found on the menu bar, at the upper right corner
of the screen).
2.
Move the cursor over the button or box to be
explained.
3.
To hide Balloon Help, select
the
menu.
Help
Selecting the correct driver
Before creating any documents in your application you
should select the DP-7000 printer driver which you
installed from the CD-ROM. If you want to print
documents created when this printer driver was not
selected, first select the DP-7000 printer in the
menu, then choose
Chooser
application's
File
application's page format and other settings if needed.
Follow the steps below to select the correct printer
driver.
Chapter 3 - Installation and Operation, Macintosh
from the
Help
Hide Balloons
from your
Page Setup
menu.
Finally
change
1.
From the Apple menu, select the
2.
Click on the DP-7000 printer driver icon on the
left side of the screen. The box on the right
displays the SCSI device number of the printer.
Note:
Make sure the device number in the
menu
box is highlighted. If it is not, your printer is not being
recognised. Click on the device number a few times. If
it is still not highlighted, it is possible that the
has insufficient memory. In this case, close the
Chooser,
and select the printer from the
from
3.
If you have several identical printers connected,
click on the SCSI device number of the printer
you will use. The factory device setting is #6. To
change SCSI device numbers, see 'Specifications
and Settings' in Chapter 7.
Note 1:
If you have more than one SCSI bus in your Macintosh,
"SCSI #6 BUS #1" or similar will be displayed.
Note 2:
the
Immediately
printing is turned off. Click on the
background printing. Background printing will not be
available if you did not install the Queue Kit software.
run any one of your application programs,
Chooser
following
installation,
On
English
.
Chooser
Select a SCSI port
Finder
again.
background
button to enable
31
Advertisement
Table of Contents
Troubleshooting
