Table of Contents
Advertisement
multiple sheets to feed into the printer at the same
time, or other forms of misfeed.
The printer emits unusual noises when the power
is turned on, and the error lights blink
1
Has the carriage packing material been
removed?
Refer to Chapter 1, Introduction for details on
removing packing material.
2
Has the packing tape been removed?
There are two pieces of tape on the front of the
printer that help protect the printer during
shipping. Gently remove the tape before using the
printer.
3
Has a cartridge become dislodged from the cartridge
holder?
Open the front cover and make sure the cartridges
are correctly installed.
4
Is there a paper jam?
Clear a paper jam by refering to 'Clearing Paper
Jams' in this Chapter. Occasionally a small piece
of paper will tear off and remain in the printer. If
this happens, hold the release lever down and use
84
a thick piece of paper to remove the small piece
of paper.
A mechanism or cartridge change error occurred
1
Are the cartridges installed correctly?
If a cartridge has become dislodged from its
holder, a cartridge change error will occur. Open
the front cover and reinstall the cartridge.
2
Are you using the printer on a level surface?
The printer will not operate correctly on a slanted
surface. Place it on a level, stable surface.
3
Is the printer in a place where it is subject to
movement?
Various movements such as bumps and vibrations
can cause mechanical problems. Place the printer
in an environment where it will not be subject to
movement.
4
Is the front cover properly closed?
The printer will not operate correctly if the front
cover is not closed properly. Close the front cover
all the way.
User's Guide
Advertisement
Table of Contents
Troubleshooting
