Table of Contents
Advertisement
A high impedance cable is recommended for use as the
SCSI cable. With other cables, unstable working can be
expected. An active terminator is recommended as the
terminator.
Caution SCSI ID:
The initial SCSI ID of the SCSI adapter has been set as 6.
To change the ID, set the ID by using the dip switch (5).
Regarding details, refer to [Dip Switch Setting (Macintosh
SCSI Connection)] in [Chapter 7 Specification & Setting].
If any SCSI peripheral devices other than this printer are
connected to the computer, and if the SCSI ID of this
printer and other peripheral devices are the same, it is
possible that this printer and other SCSI peripheral devices
will not work properly.
How to uninstall SCSI adapter
1.
Turn off the computer, the printer and all
peripheral devices connected using SCSI.
2.
Unplug the power cord from the printer.
3.
Disconnect the SCSI cable and the terminator
from the SCSI adapter.
4.
Uninstall SCSI adapter.
As shown in the drawing, pull out the SCSI
Chapter 2 - Initial Setup
adapter by taking hold of the part shown by the
arrows.
English
17
Advertisement
Table of Contents
Troubleshooting
