Installing Modules And Cables In The Chassis; Fixed 4X10-Gigabit Ethernet Ports - Cisco ASR 9001 Hardware Installation Manual

Installing Modules and Cables in the Chassis

This chapter contains the procedures for installing cards and modules into the chassis, after it has been
installed in a rack. It also describes how to connect cables to the ports and RP.
•
•
•
•
•
•
•
•

Fixed 4x10-Gigabit Ethernet Ports

The Cisco ASR 9001 Router has four integrated 10 GE small form-factor pluggable (SFP+) ports that operate
at a rate of 10 Gbps.
Each fixed SFP+ port has an adjacent Link LED visible on the front panel. The Link LED indicates the status
of the associated SFP+ port.
In Cisco ASR 9001-S Router, two 10 GE fixed SFP+ ports (SFP+2 and SFP+3) are disabled by default,
Note
and can be enabled by a license upgrade.
Fixed 4x10-Gigabit Ethernet Ports, page 57
Modular Port Adapters, page 58
Installing and Removing Modular Port Adapters, page 67
Installing and Removing SFP and XFP Modules, page 73
Cable Management, page 73
Connecting Route Processor Cables, page 77
Connecting Power to the Router, page 80
Powering on the Router, page 83
C H A P T E R
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
3
57