Antenna Connection; Bios Security Switch; Figure 6. Location Of The Antenna Connectors - Intel NUC 8 Product Specification

Intel® NUC 8 Compute Element Product Specification
3.4
The NUC 8 Compute Element wireless module does not have any antennas connected. For
wireless and Bluetooth operation appropriate antennas will be required. Depending on the
enclosure design internal or external antennas can be supported. Figure 6 shows the location of
the two antenna connectors on the Mylar side.
The wireless module uses a standard 2x2 mm size RF micro coaxial receptacle (connector) with an
outer diameter of 1.5 mm as defined in the PCI-E M.2 Specification. Specific plugs should be
selected to suit the assembly allowable mating height and cable diameter. Refer to the PCI-E M.2
Specification for the minimum requirements of the compatible RF connectors and mating plugs.
•
•
3.5
Figure 7 shows the location of the BIOS Security Switch. The 3-position switch determines the BIOS
Security program's mode.
CAUTION
Do not change the switch with the power on. Always turn off the power and unplug the power cord
from the carrier board before changing a switch setting. Otherwise, the board could be damaged.
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from

Antenna Connection

Figure 6. Location of the Antenna Connectors

Receptacle physical outline is 2mm x 2mm x 0.6mm
Receptacle outer diameter is 1.5mm

BIOS Security Switch

19