Creating Ssu Diskettes - NEC LS2400 User Manual

Creating SSU Diskettes

SSU may be run directly from the E
DOS-bootable diskettes. Before you can run the SSU from diskettes,
you must copy the SSU from the E
diskette.
If your diskette drive is disabled, or improperly configured, you must
use the FLASH-resident BIOS Setup Utility (F2) to enable it so that you
can use the SSU. If necessary, you can disable the drive after you exit
the SSU. Information entered using the SSU overrides information
entered using Setup.
Note: Because of license restrictions, the SSU diskette, as
created by the EXPRESSBUILDER CD-ROM, is not bootable.
In order to use this diskette, you must make it bootable.
1. Power on the system.
2. If the diskette drive is disabled, enable it using the BIOS Setup
Utility, explained later in this chapter. Specify the correct type of
diskette drive.
3. Using the E B CD-ROM, create the SSU diskette.
XPRESS UILDER
B CD-ROM or from
XPRESS UILDER
B CD-ROM to a
XPRESS UILDER
System Setup Utility B-3