NEC LS2400 User Manual page 96

9. Replace the 3.5-inch drive bay. Insert the tabs into their slots on the
chassis. Slide the drive bay towards the bottom of the chassis until
the tabs hit their stops.
10. Connect the signal and power cables to the drives. All device power
cables are labeled and must be installed in specific locations as
shown below:
Drive Location
1 (HD0)
2 (HD1)
3 (HD2)
4 (HD2)
11. Swing the drive bay into the chassis and replace the three screws on
the drive bay.
12. Replace the left side panel and power on the system. Configure the
system as described in Chapter 3, "Configuring Your System."
4-24 Upgrading Your System
1
2
3
4
Removing the Disk Drive Bay
Power Connector
P7
P8
P9
Any available
power connector