Table of Contents
Advertisement
Symbios Configuration Utility
The Symbios Configuration Utility detects the two SCSI host adapters
located on the system board. Use the utility to:
Change adapter and SCSI device default values
!
Check and/or change SCSI device settings that may conflict with
!
those of other devices in the server.
Perform low-level formatting or verify operations on SCSI disk drives.
!
Running the Symbios Configuration Utility
1. Power-on the system. The system boots up.
2. When this message appears on the video monitor:
Press Ctrl-C to start the Symbios Configuration Utility
Press Ctrl+C to run this utility.
3. The utility starts and the Main Menu displays.
Adapter
Port
Number
SYM53C875
F800
SYM53C875
F400
Change Adapter Status – Press ENTER twice to change adapter Next Boot Status.
Adapter Boot Order – Press ENTER to select and change boot order of each SCSI adapter.
Additional Adapter Configuration – Not used.
Display Mode-Verbose – Press ENTER to change display mode.
Mono/Color – Press ENTER to change display from black/white to color.
Language – Not used.
Help/Quit
*Next Boot Status for this controller must be turned OFF if you install the optional
Mylex AcceleRAID Controller board. Refer to "Change Adapter Status" above.
3-20 Configuring Your System
Symbios Configuration Utility Main Menu
IRQ Level
Current
11
On
10
On
Status
NVRAM
Found
Next Boot
On*
Yes
On*
Yes
Advertisement
Table of Contents
Troubleshooting
