NEC LS2400 User Manual page 85

8. Remove the new processor from its antistatic package and place it on a grounded,
static-free surface or conductive foam pad..
9. Position the processor into the URM. Ensure that the alignment notch on the bottom
of the cartridge fits into the connector key in the slot (A). Push down firmly, with
even pressure on both sides of the top until the cartridge is seated.
A B
10. Connect the fan cable to fan connector (B) on the system board.
11. After you have installed a new processor, you must run the BIOS Setup Utility (F2)
to configure its speed. Refer to Chapter 3, "Configuring Your System."
12. Replace the left side panel and power up the system.
Installing a Processor
Upgrading Your System 4-13