Creating Ssu Diskettes; Running The Ssu - NEC MH4500 User Manual

Creating SSU Diskettes

SSU may be run directly from the E
bootable diskettes. Before you can run the SSU from diskettes, you must copy
the SSU from the E
If your diskette drive is disabled, or improperly configured, you must use the
FLASH-resident BIOS Setup Utility (
SSU. If necessary, you can disable the drive after you exit the SSU. Information
entered using the SSU overrides information entered using Setup.
1. Power on the system.
2. If the diskette drive is disabled, enable it using the BIOS Setup Utility (see
Chapter 3, "Configuring Your System'). Specify the correct type of diskette
drive.
3. Using the E
Note:
blocks". Run CHKDSK or Format to check the quality of the
diskettes.

Running the SSU

Use the following steps to run the SSU.
1. Power up your monitor and system.
2. Start the SSU using one of the following methods.
T
After creating the three SSU diskettes from the CD:
T
Directly from the Server Configuration CD:
3. Follow the system prompts to load the SSU. When the SSU title appears on
the screen, press
4. The mouse driver loads, if available. Press
B
XPRESS UILDER
B CD-ROM, create the SSU diskette.
XPRESS UILDER
Ensure the diskettes do not contain any "bad
Insert SSU diskette 1 into Drive A and reboot your server from the
diskette.
Insert the configuration CD in your CD-ROM drive and reboot your
server from the CD. When prompted, press
From the Boot menu, select Boot Device Priority and select CD-
ROM as your primary boot device
Save the settings and exit the BIOS Setup.
Reboot your server from the CD. The server displays a menu of
options.
to continue.
Enter
B CD-ROM or from DOS-
XPRESS UILDER
CD-ROM to a diskette.
) to enable it so that you can use the
F2
F2
to continue.
Enter
System Setup Utility B-3
to enter BIOS Setup.