• Inserting the bobbin
(_ End of thread
(_) Notch
(_) Notch
(_) Threading chart
[]
Place a bobbin in the bobbin holder with the thread
running off counterclockwise.
[] Guide the thread into the notch _ on the front side of the
bobbin holder. Draw the thread to the left, sliding it between
the tension spring blades.
[] Continue to draw the thread lightly until the thread slips into
the notch @. Pull out about 6.0" (15.0cm) of thread.
[] Attach the hook cover plate. Check the threading by
referring to the chart ® shown on the hook cover plate.
[]
[]
[]
[]
J
24