Automatic Tach Programming; Horn Chirp Timing; Testing - Autostart AS-2510 TW Installation Manual

Note
The L.E.D. follows the Parking Lights during the
Transmitter Programming procedure.
At any time, close the Hood to end the Tach-
programming procedure.

Automatic Tach Programming

This simple procedure can replace the Multi-speed Tach Programming procedure:
1. Make sure that all the connections are properly made and that the Remote Car
Starter is powered up.
2. With the Hood up (ground on the Hood Pin switch line), start the vehicle using the
Key.
3. Allow the vehicle to reach regular Engine idle speed.
The Parking Light output from the Remote Car Starter will activate when the
vehicle starts and shut off once a Tach signal is detected.
4. Press the Brake Pedal and keep it down until you hear the Parking Lights Output
flash 5 times.
5. Shut down the Engine. Tach Programming is now complete.

Horn Chirp Timing

Follow these steps to program Horn Confirmation:
1. Ensure that the Hood is up and that the Ignition is
Hold the Hood Pin-switch down for 4 seconds.
Release the Pin-switch. The Parking Lights will come on.
While the Parking Lights are on, immediately push and release the
Pin-switch again. The Parking Lights will stay on for up to 20 seconds.
2. Press and hold the Brake Pedal, then simultaneously press the
buttons on the Transmitter – the Horn will chirp 5 times.
3. Release the Brake Pedal.
4. To change the timing:
a. To increase the Horn pulse by 3 ms, press the
b. To decrease the pulse by 3 ms, press the
c. To increase the pulse by 10 ms, press the
d. To decrease the pulse by 10 ms, press the
5. To save the new settings: press
settings have been saved.
Otherwise close the Hood to cancel the changes.
For each timing change, the Horn will chirp with the new settings, except in the
following cases:
When the lower limit of 5 ms is reached, there will be a 1/4-sec. chirp.
When the upper limit of 200 ms is reached, there will be a 3/4-sec. chirp.
A system reset will set the Remote Car Starter back to the default values: 30 ms.

Testing

Before putting back the vehicle together, it is recommended to check that the system
operates properly. The following testing procedures should be used to verify proper
P. 14
Table 6: Automatic Tach Programming
LOCK
UNLOCK
START
TRUNK
and
LOCK UNLOCK
Table 7: Adjusting Chirp Duration
.
OFF
and
UNLOCK START
button.
button.
or button.
STOP
button.
. If 3 chirps are returned the new
Installation Guide AS-2510 TW