Table of Contents
Advertisement
USING SETUP MODE
CHANGING
HARDWARE
OPTIONS
5-35
User's Manual
Resetting MENU1 and MENU2
To reset the factory defaults for both MENU1 and MENU2, select the
DEFAULT/INITIAL function. For more information, see the section
Resetting Defaults later in this chapter. The DEFAULT function cannot
reset those options which are handled by the HARDWRE, ADJUST,
CONFIG, and GAP-ADJ functions. The INITIAL function can reset
those options which are handled by the HARDWRE, ADJUST,
CONFIG, and GAP-ADJ functions.
The HARDWRE function defines the printer's hardware operating
conditions. If you are using the optional RS-232C serial interface, the
serial interface options must be set properly for the printer to function
correctly with your system hardware.
Table 5.5 describes the HARDWRE items and options. Items are listed in
the order in which they are printed. The procedure for changing the
hardware options is described after Table 5.5.
Table 5.5 HARDWRE Items and Options
NOTE: Underlined options are the factory defaults.
HARDWRE
Options
Items
<PPR-OUT>
CNTONLY
DETECT
IGNORE
Description
Specifies how the printer responds when you
run out of paper.
The printer detects paper-out only for
continuous forms. Printing stops and the
PAPER OUT indicator lights red.
The printer detects paper-out for both
continuous forms and single sheets. Printing
stops and the PAPER OUT indicator lights
red.
The printer ignores paper-out for both
continuous forms and single sheets. Printing
continues until no more data remains. No
PAPER OUT warning is displayed.
USING SETUP MODE
User's Manual
5-35
Advertisement
Table of Contents
