Using Single Sheets; Loading A Single Sheet Of Paper - Fujitsu DL3750+/3850+ User Manual

USING SINGLE SHEETS

User's Manual
Table 3.2 Paper Thickness Lever Settings
Number of Copies
(Including the Original) *1
1 copy
2 copies
3 copies
4 copies
5 copies
Ribbon replacement
*1 For carbon-interleaved paper, the carbon counts as one copy.
*2 Vary the setting up or down (including A to D) to optimize printing.
Select D when replacing a ribbon or clearing a paper jam. For labels
and envelopes, use trial-and-error to determine a satisfactory setting.
NOTE
If printing is messy, the ribbon misfeeds, or the paper jams, move the
lever one setting higher.
This section describes how to load paper in the cut sheet stand.
The cut sheet stand allows paper to be loaded manually, one sheet at a time.

Loading a Single Sheet of Paper

To load a sheet of paper into the cut sheet stand:
1. Make sure that the printer is turned on. Check that rear-fed continu-
ous forms are retracted to the park position. (For details, see the
section Unloading Continuous Forms later in this chapter.)
PAPER HANDLING
Setting *2
1
2
3
4
5
D
3-5