Tearing Off Continuous Forms - Fujitsu DL3750+/3850+ User Manual

User's Manual

Tearing Off Continuous Forms

Your printer has a special "tear-off edge" that allows you to tear off printed
pages without wasting paper. The tear-off edge is located on the ejection
cover.
To tear off continuous forms using the tear-off edge:
1. Press the TEAR OFF button. The bottom perforation of the last page
advances to the tear-off edge. If you specified TEAR OFF: AUTO
using the CONFIG function in setup mode, the paper automatically
advances to the tear-off edge at the end of each job (or when the
printer has printed all the data received).
NOTE
If the bottom perforation of your paper is not positioned at the
tear-off edge, the length of your paper may not be specified
correctly in your software or the printer setup mode. Check that
the paper length is specified correctly. For information on
specifying page length using setup mode, see Chapter 5.
2. Tear the paper off at the perforation.
Tearing off continuous forms
3. Press any button to retract the forms back to the top-of-form position.
PAPER HANDLING
3-15