Fujitsu DL3750+/3850+ User Manual page 120

USING SETUP MODE
5-42
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG Items Options
<TEAR-EN>
(continued)
<CUTLOAD>
AUTO
BUTTON
The following <LOADTIM> item is printed when CUTLOAD:AUTO is
specified for the <CUTLOAD> item.
<LOADTIM>
0.5, 1.0,
1.5, 2.0
2.5, 3.0SEC single sheet paper.
<DECODE>
DIRECT
QUEUED
Description
In some application programs, data
transfer may stop temporarily due
to internal processing. This setting can
avoid an undesired tearoff feed by
waiting for up to six seconds each time
data transfer stops.
Single sheet autoloading.
Single sheet paper is automatically
loaded a certain time after you set
the paper.
Single sheet paper can be loaded by
pressing the LOAD button.
Autoload start time.
Autoloading starts when this
amount of time passes after you set
Command decode timing.
The printer decodes certain commands
immediately after receiving data.
Example:
ESC SUB I, ESC CR P (DPL24C+)
ESC Q # (IBM XL24E)
The printer decodes commands after
storing all data (including commands)
in the input buffer. This speeds data
reception because the printer does not
require decoding time during data
reception.
User's Manual