Fujitsu DL3750+/3850+ User Manual page 115

User's Manual
Table 5.5 ADJUST Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
ADJUST
Options
Items
<CNT-LFT>
–10/90, ..., 0/90,
..., 10/90
<CUT-LFT>
–10/90, ..., 0/90,
..., 10/90
<CUT-ADJ>
–21/360, –14/360,
–7/360, 0/360,
7/360, 14/360, 21/360,
GRAPHIC (*1)
–28/360, –21/360,
<CNT-ADJ>
–14/360, –7/360, 0/360,
7/360, 14/360, 21/360,
28/360, GRAPHIC (*1)
–21/360, –14/360,
<CNTADJL>
–7/360, 0/360,
7/360, 14/360, 21/360,
GRAPHIC (*1)
*1:When printing graphics, selecting "GRAPHIC" may result in the
printing of clearer graphics.
USING SETUP MODE
Description
Fine-tunes the left print start
position for continuous forms.
Moves the position left or
right in increments of 1/90
inch (0.28 mm).
Fine-tunes the left print start
position for single sheets.
Moves the position left or
right in increments of
1/90 inch (0.28 mm).
Compensates the line spacing
pitch on the basis of the
spacing error accumulated for
feeding single sheets by10
inches.
Decreases or increases in
increments of 1/360 inch in
total.
Compensates for the forms
feed error accumulated
through feeding of continuous
forms.
Compensates for the forms
feed error accumulated
through feeding of continuous
forms. (Last page)
5-37