Fujitsu DL3750+/3850+ User Manual page 146

MAINTENANCE
6-6
9. Align the print head position with the dot mark (green) on the printer
ejection cover.
WARNING
Avoid touching the print head while using or immediately after using the
printer, as doing so may lead to burns. Wait until the print head cools
down before touching it.
10. Thread the ribbon between the print head and the print guide, then
gently press down on the ribbon cartridge against the printer until it
clicks into place.
(Make sure that the ribbon feed knob is facing upward.)
Ribbon cartridge
11. Turn the ribbon feed knob clockwise to take up any ribbon slack.
12. Move the paper thickness lever back to its original position. For
single sheet printing, the correct position is 1. Table 3.2 in Chapter 3
gives other paper thickness lever settings.
13. Close the front cover of the printer.
Dot mark (green)
Print guide
Print head
Ribbon
Print guide
Tip of print head
User's Manual