Dell PowerConnect W-Airwave User Manual page 81

Figure 39 Groups > Security Page Illustration
Table 51 Groups > Security Page Fields and Default Values
Setting
VLANs Section
VLAN Tagging and Multiple
SSIDs
Management VLAN ID
Permit RADIUS-Assigned
Dynamic VLANs
VLAN ID Format
Ethernet Untagged VLAN ID
(1-4094)
General Section
Create Closed Network
Block All Inter-client
Communication
Dell PowerConnect W AirWave 7.2 | User Guide
Default Description
Enabled This field enables support for VLANs and multiple SSIDs on the wireless network. If
this setting is enabled, define additional VLANs and SSIDs on the Groups > SSIDs
page. Refer to "Configuring Group SSIDs and VLANs" on
Untagged This setting sets the ID for the management VLAN when VLANs are enabled in
AWMS. This setting is supported only for the following devices:
Proxim AP-600, AP-700, AP-2000, AP-4000

Avaya AP-3, Avaya AP-7, AP-4/5/6, AP-8

ProCurve520WL; ProCurve420

Enterasys AP3000

No This setting enables dynamic VLANs to be assigned by the RADIUS server. This
setting is supported only for HP ProCurve 420.
Hex This setting defines the naming convention for VLANs to be supported in AWMS.
The supported naming formats are ASCII and Hexadecimal.
1 This field defines the VLAN that will use untagged Ethernet. The VLAN must be a
number between 1 and 4094, and defines the untagged VLAN ID for the RoamAbout
AP3000.
No If enabled, the APs in the Group do not broadcast their SSIDs.
NOTE: Creating a closed network will make it more difficult for intruders to detect
your wireless network.
No If enabled, this setting blocks client devices associated with an AP from
communicating with other client devices on the wireless network.
NOTE: This option may also be identified as PSPF (Publicly Secure Packet
Forwarding), which can be useful for enhanced security on public wireless
networks.
page 83.
Configuring and Using Device Groups in AWMS | 81