Dell PowerConnect W-Airwave User Manual page 74

Table 37 Basic and Global Groups Fields and Default Values (Continued)
Setting
Missed SNMP
Poll Threshold
Regulatory
Domain
Timezone
Allow One-to-
One NAT
Audit
Configuration on
Devices
Use Global
Group
4. Complete the SNMP Polling Periods section. The information in this section overrides default settings.
Table 38
Table 38 SNMP Polling Periods Fields and Default Values
Setting
Up/Down Status Polling
Period
Override Polling Period for
Other Services
AP Interface Polling Period
User Data Polling Period
Thin AP Discovery Polling
Period
Device-to-Device link Polling
Period
802.11 Counters Polling Period 5 minutes
Rogue AP and Device
Location Data Polling Period
CDP Neighbor Data Polling
Period
5. Record additional information and comments about the group in the Notes section.
74 | Configuring and Using Device Groups in AWMS
Default Description
1 Sets the number of Up/Down SNMP polls that must be missed before AWMS considers a
device to be down. The number of SNMP retries and the SNMP timeout of a poll can be set
on the Device Setup > Communication page.
United States Sets the regulatory domain in AWMS, limiting the selectable channels for APs in the group.
AMP System Allows group configuration changes to be scheduled relative to the time zone in which the
Time devices are located. This setting is used for scheduling group-level configuration changes.
No Allows AWMS to talk to the devices on a different IP address than the one configured on
the device.
NOTE: If enabled, the LAN IP Address listed on the AP/Devices > Manage configuration
page under the Settings area is different than the IP Address under the Device
Communication area.
Yes Auditing and pushing of configuration to devices can be disabled on all the devices in the
group. Once disabled, all the devices in the groups will not be counted towards
mismatched devices.
No When enabled, this field allows you to define the device group to be a Global Group. Refer
to "Using Global Groups for Group Configuration" on
describes the SNMP polling settings.
Default
5 minutes
No
5 minutes
5 minutes
5 minutes
5 minutes
5 minutes
30 minutes
Description
Sets time between Up/Down SNMP polling for each device in the group.
The Group SNMP Polling Interval overrides the global parameter configured on
the Device Setup > Communication page. An initial polling interval of 5 minutes is
best for most networks.
Enables or disables overriding the base SNMP Polling Period. If you select Yes,
the other settings in the SNMP Polling Periods section are activated, and you
can override default values.
Sets the interval at which AWMS polls for radio monitoring and bandwidth being
used by a device.
Sets time between SNMP polls for User Data for devices in the group.
Sets time between SNMP polls for Thin AP Device Discovery. Controllers are the
only devices affected by this polling interval.
Sets time between SNMP polls for Device-to-Device link polling. Mesh APs are
the only devices affected by this polling interval.
Sets time between SNMP polls for 802.11 Counter information.
Sets time between SNMP polls for Rogue AP and Device Location Data polling.
Sets the frequency in which this group polls the network for Cisco Discovery
Protocol (CDP) neighbors.
page 105.
Dell PowerConnect W AirWave 7.2 | User Guide