Adding And Configuring Group Aaa Servers - Dell PowerConnect W-Airwave User Manual

Table 49 Routers and Switches Fields and Default Values (Continued)
Setting
Interface Up/Down
Polling Period
Interface
Bandwidth Polling
Period
Interface Error
Counter Polling
Period
Poll 802.3 error
counters
Poll Cisco interface
error counters
18. To configure settings for universal devices on the network, including routers and switches that support both
wired and wireless networks, locate the Universal Devices, Routers and Switches section of the Groups >
Basic page and define the version of SNMP to be supported.
19. Select Save when the configurations of the Groups > Basic configuration page are complete to retain these
settings, but without pushing these settings to all devices in the group. Save is a good option if you intend to
make additional device changes in the group, and wish to wait until all configurations are complete before you
push all configurations at one time.
Select Save and Apply to make the changes permanent, or select Revert to discard all unapplied changes.
What Next?
Continue to additional sections in this chapter to create new groups or to edit existing groups.
Once general group-level configurations are complete, continue to later chapters in this document to add or edit
additional device-level configurations and to use several additional AWMS functions.

Adding and Configuring Group AAA Servers

Configure RADIUS servers on the Groups > AAA Servers page.
Once defined on this page, RADIUS servers are selectable in the drop-down menus on the Groups > Security
and Groups > SSIDs configuration pages. Perform these steps to create RADIUS servers.
NOTE: TACACS+ servers are configurable only for Cisco WLC devices. Refer to
on page 96.
1. Go to the Groups > List page and select the group for which to define AAA servers by selecting the group
name. The Monitor page appears.
2. Select the AAA Servers page. The AAA Servers page appears, enabling you to add a RADIUS server.
illustrate this page for AAA RADIUS Servers:
Dell PowerConnect W AirWave 7.2 | User Guide
Default Description
5 minutes Sets the frequency in which network interfaces are polled for up/down status. This setting
can be disabled, or set to poll from switches in a range from every 15 seconds to 30 minutes.
15 Sets the frequency in which network interfaces are polled for bandwidth usage. This setting
minutes can be disabled, or set to poll from switches in a range from every 5 minutes to 30 minutes.
30 Sets the frequency in which network interfaces are polled for up/down status. This setting
minutes can be disabled, or set to poll bridge forwarding tables from switches in a range from every 5
minutes to 30 minutes.
No Sets whether 802.3 error counters should be polled.
No Sets whether the interface error counters for Cisco devices should be polled.
"Configuring Security Parameters and Functions"
Configuring and Using Device Groups in AWMS | 79
Figure 38