Configuring Wlans For Cisco Wlc Devices - Dell PowerConnect W-Airwave User Manual

Configuring WLANs for Cisco WLC Devices

In Cisco WLC Config, WLANs are based on SSIDs or VLANs that are dedicated to Cisco WLC controllers.
Perform the following steps to define and configure WLANs for Cisco WLC controllers.
1. Go to the Groups > Cisco WLC Config page, and select WLANs in the navigation pane at left. This page
displays the SSIDs or VLANs that are available for use with Cisco WLC devices, and enables you to define
new SSIDs or VLANs.
2. To change the ID/position of a WLAN on the controller by dragging and dropping, set the toggle to yes. Note
that the by setting this flag to yes, AMP will display a mismatch if the WLANs in the desired and device
config differ only on the order.
Figure 45 Groups > Cisco WLC Config > WLANS page illustration
3. To add or edit SSIDs or VLANs that are dedicated to Cisco WLC devices, either select the Add New SSID/
VLAN button, or select the pencil icon for an existing SSID/VLAN. A new page appears comprised of four
tabs, as follows:
General—Defines general administrative parameters for the Cisco WLC WLAN.

Security—Defines encryption and RADIUS servers.

QoS—Defines quality of service (QoS) parameters for the Cisco WLC WLAN.

Advanced—Defines advanced settings that are available only with Cisco WLC devices, for example, AAA

override, coverage, DHCP and DTIM period.
NOTE: Refer to Cisco documentation for additional information about Cisco WLC devices and related features.
Figure 46 Groups > Cisco WLC Config > WLANs > Add New SSID/VLAN > General Tab Illustration
Dell PowerConnect W AirWave 7.2 | User Guide
Figure 45 illustrates this page.
Configuring and Using Device Groups in AWMS | 93