Defining Awms Network Settings - Dell PowerConnect W-Airwave User Manual

Table 15 AMP Setup > General > Performance Tuning Fields and Default Values (Continued)
Setting
Maximum Number of
Audit Processes
Verbose Logging of
SNMP Configuration
SNMP Rate Limiting
for Monitored
Devices
RAPIDS Processing
Priority
10. Select Save when the General Server settings are complete and whenever making subsequent changes.
What Next?
Go to additional tabs in the AMP Setup section to continue additional setup configurations.

Complete the required configurations in this chapter before proceeding. Dell support remains available to you for

any phase of AWMS installation.

Defining AWMS Network Settings

The next step in configuring AWMS is to confirm the AMP network settings. Define these settings by navigating
to the AMP Setup > Network page.
Figure 16 AMP Setup > Network Page Illustration
Perform the following steps to define the AWMS network settings:
Dell PowerConnect W AirWave 7.2 | User Guide
Default Description
3 Increases the number of processes that audit configurations for your devices,
as an option. The optimal setting for your network depends on the resources
available, especially RAM. Contact Dell support if you are considering
increasing this setting for your network.
No Enables or disables logging detailed records of SNMP configuration
information.
No When enabled, AWMS fetches SNMP data more slowly, potentially reducing
device CPU load. Dell PowerConnect W recommends enabling this global
setting when monitoring Dell PowerConnect W controllers only if your network
contains a majority of legacy controllers (800, 2400, 5000, controllers that use
Supervisor Module II). If your network mainly uses newer processors (3000
series, 600 series, the M3 module in the 6000 series), Aruba strongly
recommends disabling this setting.
Low Defines the processing and system resource priority for RAPIDS in relation to
AWMS as a whole.
When AWMS is processing data at or near its maximum capacity, reducing the
priority of RAPIDS can ensure that processing of other data (such as client
connections and bandwidth) is not adversely impacted.
The default priority is Low. You can also tune your system performance by
changing group poll periods.
Figure 16 illustrates the contents of this page.
Configuring AWMS | 41