Table of Contents
Advertisement
This chapter provides information and procedures for installing hardware options on ProLiant
DL140 server. For additional instructions, refer to the installation documentation shipped with
each option kit,
To streamline the installation process, read the installation instructions for all of the hardware
options and identify similar steps before beginning installation.
After installing all hardware options, proceed with the server installation procedures in Chapter 4.
Accessing Internal Server Components
This section defines standard procedures to access internal server components. Procedures will
vary depending on whether the server is in the rack and powered on.
When the server is not installed in the rack, accessing internal components requires removal of
the access panel.
Shutting down and removing the server from the rack
1. Power down the server and remove it from the rack.
a. Shut down the operating system as directed in the operating system instructions.
CAUTION: Whenever installing hardware or performing maintenance
procedures requiring access to internal components, it is recommended that all
server data be backed up to avoid loss.
b. Press the server Power On/Off switch (1) to power down the server. The Power On/Off
LED should change from green to off.
HP ProLiant DL140 Server Setup and Installation Guide
All manuals and user guides at all-guides.com
Installing Hardware Options
3
7
Advertisement
Table of Contents
Troubleshooting
