Ricoh FW780 Service Manual page 87

[G]
[A]
A, B
[D]
NOTE: To ensure grounding, paint has been removed from the surfaces around
the screw holes [A] (only from the surfaces where the two components
meet) and from the surface around the screw hole [B] at the inside of the
left plate.
1. Temporarily install the top plate [C], left [D], and right side plate [E] (6 screws).
2. Turn the table up-side down in the direction of A.
3. Install the middle plate [F] and rear cover [G] (4 screws each).
4. Tighten all the screws until the spring washers [H] of screws are flattened.
5. Flip the table the correct way.
SM
[D]
[A]
[A]
[B]
3-13
[E]
[H]
[C]
[A]
[E]
[C]
[A]
[F]
Rev. 5/95
A163