Ricoh FW780 Service Manual page 369

Joint harness [G] — Copier Main Control board (3 clamps)
AC harness [H] — AC Drive board [I]
[A]
[C]
B435I107.WMF
B435I125.WMF
13. Install the grounding plates [A] (1 screw for each: M4x8).
14. Secure the grounding wire [B] (1 screw: M4x8 with a spring washer) to the
copier.
NOTE: To ensure proper grounding, tighten the ground wire's screws until the
spring washer is completely flat.
15. Install the harness covers [C] (1 screw for each: M4x10 with flat washers).
NOTE: Fold the harness covers around the harness, then attach with a single
screw.
16. Reinstall the rear cover of the roll feeder (6 screws).
17. Clamp the power cord to the rear cover of the roll feeder (2 screws: M4x8).
18. Put back the copier's rear cover.
SM
[B]
[A]
[C]
3-25
INSTALLATION PROCEDURE
B435I109.WMF
B047/B048