Ricoh FW780 Service Manual page 377

Mode No.
Length Size
Magnification
*17
Semi-synchro Cut
Original Scanning
Mode
*18
Synchro-cut Length
Adjustment
*19
Paper Length
Count Up/Down
*20
Setting
Paper Length
Up/Down Speed
Setting
*21
Fixed Paper Size
*22 Pattern Setting
Optional Paper
*23 Size Setting
to
*32
AOF
*33
Start Key Enable
*34
All Indicators ON
35
SM
Function
Adjusts the speed of the original feed
motor (B048 copier only).
The setting can be changed by the key
operation.
Sets the cutting method for semi-
synchro cut mode (B047 copiers only).
When using the default method, the
user must manually press the roll
paper cut key as the trailing edge of
the original passes the table's edge.
When using the alternate method, the
user feeds the original once, and the
original length is measured. The user
then feeds the original a second time,
and it is scanned and copied. The copy
is automatically cut to the appropriate
length.
Adjusts the cut length in the semi-
synchro cut mode (B047 copier).
Adjusts the cut length in the synchro
cut, preset cut, and variable cut modes
(B048 copier). The setting can be
changed by a key operation.
Determines weather the paper length
cycles down (to smaller sizes) or up (to
larger sizes) when the preset cut key is
pressed.
This sets the speed at which the paper
length setting increases or decreases.
When the customer holds down the +
or – key, there is a brief pause. After a
selected number of 0.25 second
intervals (See SP12), the values begin
to change at the selected speed.
Selects the fixed paper size pattern
chosen when the "Preset Cut" key is
pressed.
Up to 10 different paper size can be
stored in SPs 23 to 32. If "19" is
selected in SP No. 22, these values
are used when the "Preset Cut" key is
pressed.
Auto off enable.
Select whether the start key can be
used as a start trigger.
Turns ON all indicators on the
operation panel when the Roll Feed
Select key is pressed.
4-3
SERVICE TOOLS
Data
–1.0 1.0
0.0
Shorter Longer
0: Pressing the roll
paper cut key
1: Inserting the original
again
–25 25
0
Shorter Longer
1 mm/step
0: Down
1: Up
0: 0.10 second
1: 0.5 second
2: 0.25 second
3: 0.05 second
4: 0.02 second
5: 0.01 second
Refer to page 4-24.
UdEF: Undefined
0: Disable
1: Enable
0: Disable
1: Enable
0: No
1: All indicators on
B047/B048