Ricoh FW780 Service Manual page 452

Tech Service Bulletin No. FW740 - 010
Page 2 of 2
2. Vellum
Paper TA-70
Environ L/L M/M H/H L/L
Mode 8
Mode 7
Mode 6 O
Mode 5 O
Mode 4
Mode 3
Mode 2
Mode 1
3. Film
Paper Azon Film 3mil
Environ L/L M/M H/H L/L
Mode 8
Mode 7
Mode 6
Mode 5
Mode 4
Mode 3 O O
Mode 2
Mode 1
FOR NON-LISTED PAPERS :
The following is the procedure to determine the best Fusing Temperature Setting for each type of pap er.
The best setting is said to be the highest position before creasing begins to appear.
1. Set the Fusing Temperature Setting to the maximum mode for the type of paper, such as Plain
Paper, Vellum, or Film using SP #1, SP #2 or SP #3.
2. Make 3 white copies with the largest size of the paper available in the vertical grain direction. W hite
copy is the worst case for creasing.
3. Check whether creasing appears on any of the copies.
4. If creasing appears, lower the Fusing Temperature Setting by 1 and repeat Steps # 2~4.
Azon Vellum
M/M H/H L/L
O O O
O
Azon Film 4mil
M/M H/H L/L
O O O
O
Plain Paper: Mode 7 (SP #1)
Vellum: Mode 8 (SP #2)
Film: Mode 5 (SP #3)
Erazable Vellum Regma 91gr
M/M H/H L/L
O O O
O
Regma Film 3mil Regma Film 4mil Hoechst Film
M/M H/H L/L
O
O O O
M/M H/H
O O
4mil
M/M H/H L/L M/M H/H
O O O O O