INSTALLATION PROCEDURE
3.2.4 ROLL FEEDER (A571)
CAUTION
Unplug the copier power cord before starting the following procedure.
Accessory Check
Check the accessories and their quantities according to the following list:
Harness Cover ....................................................................... 2 pcs
Angle Bracket ......................................................................... 1 pc
Spacer ................................................................................... 1 pc
Small Cap ............................................................................... 1 pc
Screws - M4 x 8 ..................................................................... 8 pcs
Screws with Spring Washer - M4 x 8 ...................................... 2 pcs
Washer (220 ~ 240 V versions only) ....................................... 2 pcs
Ground Plate (220 ~ 240 V versions only) .............................. 2 pcs
Screws with Spring Washer - M4 x 8 for Ground Plate
(220 ~ 240 V versions only) .................................................... 2 pcs
NOTE: When the Roll Feeder is installed on the copier, the table (A714 or A836) is
required.
A251/A252
3-18
SM